Power UNITS FOR LIFT TABLE one
Standard Description
This energy unit is created solely for the tiny lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit is widely applied during the marketplace of logistic devices which include minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled by the solenoid valve with the pace managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is intended exclusively for your medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as the speed managed through the adjustable needle valve. Once the lift rises to a high positoin, however the electrical power supply is reduce, the decreasing motion is controlled through the manual override perform.
Power UNITS FOR LIFT TABLE three
Common Description
This energy unit is designed solely for your large lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and the velocity managed by a pressure compensated flow handle valve.
Power UNITS FOR LIFT TABLE four
General Description
This electrical power unit is designed exclusively for the significant lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve and also the pace managed from the adjustable needle valve. Once the lift rises to a high positoin, but the power provide is lower, the decreasing movement is managed from the guide override function.
Particular Notes
one. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic elements concerned before set up of the power unit.
three. Viscosity from the oil shoud be 15~46 cst,which should really also be clean and totally free of impurities.N46 hydraulic oil is suggested.
4. Oil changing is needed following the original one hundred operation hours,afterwards once each and every 3000 hours.
5. The energy unit proven is made to be mounted vertically.