C Form Flex-Flex Couplings
The C Style coupling consists of two flex hubs, one sleeve and a single accessory kit consisting of seals and snap rings.
CFR Style Flex-Rigid Couplings
The CFR Variety coupling include one flex hub, one rigid hub, one particular sleeve, a single accessory kit consisting of seals and snap rings.
Functions
Straightforward and low-cost variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Available as vertical and horizontal couplings
Wide assortment of particular variations such as full-flex, flex-rigid mill motor
Normal configurations are available on the shelf
Ordering Details
Application: Driver and Driven.
Style and size of coupling, horizontal, vertical etc.
Electrical power: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance involving shaft ends (BSE).
Shaft sizes.
C and CFR Variety Couplings
Ordering Details
Puller Holes are typical on sizes four by way of twelve.
Puller Holes are available for sizes 7/8 through three.five at an additional charge.
The BSE (distance Amongst Shaft Ends) may differ in between G and G1.
Interference bores with no set screws are typical unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Segment.
More substantial sizes can be found, please consult Technical Assistance.